Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem a little old however it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. The following tips can help whether the problem is constant or intermittent.

Water Damage

If you accidentally drop your key fob in an eddy, or it is wet while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to excessive water.

It's also important to make sure the fob has completely dried out prior to opening it up and then use it again. If you detect any smells emanating from the fob like an industrial liquid smell or that of windshield washer fluid, it's another indication that it's been submerged in water.

A circuit board that is wet could cause the battery to lose its charge or even explode. If you can get your 308 keyfob out of the water, turn the button side up and shake as much water as possible before opening the casing. When you've opened it, remove the battery and wipe down the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system might not function include the battery of your coin is dead or receiver module issues signal interference, an electronic chip that is damaged. If none of these are the reason you can reset the system by disconnecting a 12 voltage battery from the car for 15 mins.

Dead Coin Battery

Peugeot cars come with remote start that lets drivers start their car from the distance, allowing them to warm up or cool down the car before they enter. This feature is extremely helpful, especially during cold winter months. The remote start system may not function due to a variety of reasons, such as the battery being dead.

A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often it's used and the location where it was purchased. The date of use is printed on the packaging or mentioned in the user's manual.

If the key fob stops working after exposure to clean tap water then you must remove the battery, then clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. In case of exposure to salty or soapy water, the chip might be fried and you will need to replace the key fob entirely.

If you're not sure whether the battery is damaged, you can check the voltage using a multimeter connected to both the terminals for plus and minus. If the voltage is lower than 12-13 volts you must replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start.

Faulty Receiver Module

If you aren't seeing the "Key Detected" It could be that your receiver module is defective. It's that part that sends an indication to the car when the key fob is activated which also acts as an immobiliser. It also stops it from starting until the correct key is used.

The cause could be various reasons, such as water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was exposed it. In this scenario, you'll have to take it off and thoroughly clean it using isopropyl or electronic cleaner. Once the battery has dried, you can try again.

If the issue continues to persist you're probably in need of a idea to see an area Peugeot specialist or locksmith. They will be able to use a diagnostic tool to assist in identifying the problem and fix it.

It can be stressful to lose your Peugeot car key. However, a professional auto locksmith can address the issue in only a few minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The chip inside your Peugeot 308 key fob is a very important part of the remote control system. If it gets damaged, your car might not start, or you could get a message saying "anti-theft active". In this instance the only option is to replace the key. Fortunately, professional auto locksmiths can provide the service in the shortest time.

The chip in the key fob of your Peugeot 308 could be damaged due to a variety of reasons, including sweat, water damage or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned promptly. You can clean the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery must then be allowed to fully dry.

Sometimes keys may be inoperable due to radio interference. This can happen when other devices use the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects around the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.

The Peugeot Key Fob 207/308 is very delicate and requires particular care. You should not drop it or peugeot 308 key fob Replacement throw it around. If you lose it, try to locate it as quickly as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative first, and then the positive.